How To Use Floor Scrubber

There are some basic things you have to take care of before you can use your floor scrubber, no matter what kind of work you are doing. It is the same thing like driving your car, you check for the oil, gas, check the rear mirror and put your seat belt on. And since a scrubber is machine too, there are some steps you will have to learn in order to use it properly.

First thing to do is to unplug the battery charger and set the cord on its place. You don't want it to fall down and make you a problem. After you take care of this, you have to install pad drive and install a pad itself. You can also use a brush, depending on what kind of work you are doing. This also means that you have to check for the recovery tank. Make sure it is empty so you do not have to stop in the middle of the work for no good reason.



It is always a good idea to check is the vacuum shut-off operational. Make sure there is nothing in the way and that you are getting the maximum out of a floor scrubber. Then check the solution tank. If there isn't enough of it, fill it up with the solution you bought. Now you are ready to start the machine.

You should select the appropriate water and pad pressure. This depends on what kind of surface you are working on. The manual should have all the setting already explained, so you have to check it for the details. After you've done that, you can start the brushes and vacuum. Now you only have to lower the squeegee and start scrubbing.

When your floor scrubber fills up the recovery tank, you should turn off the machine completely, but before you have to shut off the vacuum, brushes and water. You can now lift the squeegee and shut the whole machine off. Empty the recovery tank into drain, then you can start using the machine again. You have to start from the beginning, completing all the steps in the exact order.